home
***
CD-ROM
|
disk
|
FTP
|
other
***
search
/
Libris Britannia 4
/
science library(b).zip
/
science library(b)
/
HAM_RAD
/
3176.ZIP
/
ICOM1.ZIP
/
IC10.2
< prev
next >
Wrap
Text File
|
1991-03-10
|
2KB
|
64 lines
IC10.2
The IF-232 Interface from Kenwood is a 1488 and a 1489 chip
in a box. These are an RS-232 Quad Line Driver and Receiver
and are available at Radio Shack for $1.29 Each. Here is an
easy project that will save you a lot over the $69+ Kenwood price
of the IF-232 Interface. The 1488 needs a + and - supply.
Unregulated + and - 12vdc is just fine. Get the +5 vdc for the
1489 by putting a 7805 regulator on the +12 vdc supply. 100 ma.
is about the max you'll draw, so the smallest transformer you
can find will still be plenty large. Don't forget to series up
two of each gate to cancel the inversion that the 1480's produce.
ACC-1 Connector Use a 6 Pin DIN Connector.
(Radio Shack $1.29)
Pin Signal Comments
________________________
1 Gnd Signal Ground
2 TXD Serial Data from Radio to Computer
3 RXD Serial Data from Computer to Radio
4 CTS Computer Ready; (Radio Input)
5 RTS Radio Ready; (Radio Output)
6 No Connection
Pins 4 and 5 may be left Unconnected.
***** Command Description for Kenwood Computer Interface *****
______________________________________________________________
Auto Information
________________
AIn;
The Radio Will Send the Status Info Automatically
Whenever the Operator Manually Varies any Function
on the Radio which is Covered in the IF; Command
Where n = 0 for Auto Info OFF
1 for Auto Info On
The Status Information Will be Sent in the Form :
As defined in the IF; Command
Display Memory
______________
DMnnnn;
This is a Factory Diagnostic Function
and is of no practical use to the operator
The Contents of the MPU Memory will be Read
Where nnnn = MPU Address (0000 Thru FFFF (HEX))
The Contents of the MPU Memory Will be Sent in the Form :
DMnnnn-aabbccddeeffgghhiijjkk;
Where nnnn = MPU Address (0000 Thru FFFF (HEX))
aa~~kk = Hex Number Pairs Of Next 16 Locations
CONT IN IC10.3